Čeština
Fóra
Uživatelé
Names1
Aktivita
 
Notifications
Clear all
Names1
Names1
Skupina: Registrovaný
Přidal se: 2018/02/07
Active Member
1
Profile Aktivita
Can you explain that a bit more detailed? Is the p.i.n.d.a b...

In forum Assembly and first prints troubleshooting

 před 7 years
i found out what the problem was, it was the p.i.n.d that wa...

In forum Assembly and first prints troubleshooting

 před 7 years
Tryed to calibrate again,changed things in slicer. already c...

In forum Assembly and first prints troubleshooting

 před 7 years
FYI, I'm far far far from having any experience in 3d printi...

In forum Assembly and first prints troubleshooting

 před 7 years
now im getting less problems in the first layer but im getti...

In forum Assembly and first prints troubleshooting

 před 7 years
i will try it thank you

In forum Assembly and first prints troubleshooting

 před 7 years
Problems First Layer

In forum Assembly and first prints troubleshooting

 před 7 years
Not the perfect first layer but its printing thank you to al...

In forum Assembly and first prints troubleshooting

 před 7 years
i gonna start the unusable now, thank you for the tips later...

In forum Assembly and first prints troubleshooting

 před 7 years
ok i will rebuild it again. sorry and thank you for your hel...

In forum Assembly and first prints troubleshooting

 před 7 years
its not that the assembly went wrong is that i can not screw...

In forum Assembly and first prints troubleshooting

 před 7 years
can this be because i can only screw 1 of the screws in this...

In forum Assembly and first prints troubleshooting

 před 7 years
yes been printing the g.codes that was on the sd card, now i...

In forum Assembly and first prints troubleshooting

 před 7 years
yes i have, the z adjustment stucks to the bed no problem, p...

In forum Assembly and first prints troubleshooting

 před 7 years
Cant print anything

In forum Assembly and first prints troubleshooting

 před 7 years
Share: