Prusa3D Forum

Notifications

Clear all

Mzee3pots

Groupe: Enregistré

A(ont) rejoint: 2025/04/16

Active Member

	Ah, so perhaps my check was not good! Thank you. I will dr... Dans le forum General discussion, announcements and releases	il y a 1 month
	Thank you for your answer. I have been using a Creality dri... Dans le forum General discussion, announcements and releases	il y a 1 month
	Filament dragging over base layers Dans le forum General discussion, announcements and releases	il y a 1 month
	Hotend temperature error Dans le forum General discussion, announcements and releases	il y a 4 months
	Thanks to Chris and others I have been able to complete this... Dans le forum How do I print this? (Printing help)	il y a 9 months
	The marks on the filament appear to be formed by the gear te... Dans le forum Hardware, firmware and software help	il y a 11 months
	Filament stuck in PTFE tube and won’t unload Dans le forum Hardware, firmware and software help	il y a 11 months
	Thanks Chris. I have done the perimeter frame but your fina... Dans le forum How do I print this? (Printing help)	il y a 11 months
	"Joan; I can't upload that file format. @Chris; thanks for... Dans le forum How do I print this? (Printing help)	il y a 11 months
	Fine mesh for mosquito screen not working Dans le forum How do I print this? (Printing help)	il y a 11 months

Statistiques du forum

598 Forums

70.8 K Sujets

496.3 K Messages

17 En-ligne

82.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé