|
@jurgen-7. In forum Hardware, firmware and software help |
7 days ago |
|
That was it! A simple mechanical interference. I had the fir... In forum Hardware, firmware and software help |
7 days ago |
|
Thanks for that check. No - no problem in the right rear cor... In forum Hardware, firmware and software help |
7 days ago |
|
Here it is: Tray2top.3mf I'll be very interested in what yo... In forum Hardware, firmware and software help |
7 days ago |
|
It's off. In forum Hardware, firmware and software help |
7 days ago |
|
OK, there is definitely something wrong with the gcode in th... In forum Hardware, firmware and software help |
7 days ago |
|
Thanks for the link. I printed it using the same steps as ab... In forum Hardware, firmware and software help |
7 days ago |
|
Interesting! After auto-homing, the center is at 125 x 110 m... In forum Hardware, firmware and software help |
7 days ago |
|
Print not centered on the bed In forum Hardware, firmware and software help |
7 days ago |
|
I've had the bearings fail in the extruder stepper motor twi... In forum Hardware, firmware and software help |
3 months ago |
|
I know I said that I wouldn't post again in this thread, but... In forum Hardware, firmware and software help |
3 years ago |
|
I took the extruder motor apart and found a bad bearing. The... In forum Hardware, firmware and software help |
3 years ago |
|
Well, it's happened two more times. The symptoms are that th... In forum Hardware, firmware and software help |
3 years ago |
|
Extruder motor jam In forum Hardware, firmware and software help |
3 years ago |
|
Filament stuck after filament sensor detects break In forum Hardware, firmware and software help |
3 years ago |
|
2.4.0 slicer crashes immediately on start. I get the splash ... In forum General discussion, announcements and releases |
4 years ago |
|
I too had the sensor fail after upgrading from MK3 to MK3S. ... In forum Assembly and first prints troubleshooting |
7 years ago |
