MrMik – Activité – Prusa3D Forum

Notifications

Clear all

MrMik

Groupe: Enregistré

A(ont) rejoint: 2016/09/21

Honorable Member

	Thank you , John! I took it apart and it will indeed be ver... Dans le forum Improvements (Archive)	il y a 8 years
	Thanks, David. Is ColorPrint used for multi-color printing ... Dans le forum Print tips (Archive)	il y a 8 years
	Difference between Colorprint and ZHop Dans le forum Print tips (Archive)	il y a 8 years
	Thanks again David, explanation found! I must have shut dow... Dans le forum Hardware, firmware and software help	il y a 8 years
	Thanks David! I did do a little search, but did not use fre... Dans le forum Hardware, firmware and software help	il y a 8 years
	I went into Settings> Move Axis and the extruder is extru... Dans le forum Hardware, firmware and software help	il y a 8 years
	Print just stopped mid-way Dans le forum Hardware, firmware and software help	il y a 8 years
	Uninterruptible power supply Dans le forum Improvements (Archive)	il y a 8 years
	I think that could be a very worthwhile addition to the soft... Dans le forum Hardware, firmware and software help	il y a 8 years
	powered by the printers PSU where I added a barrel jack for ... Dans le forum Improvements (Archive)	il y a 8 years
	Great photos of enclosures in this thread, thanks! I've bee... Dans le forum Improvements (Archive)	il y a 8 years
	I added a bit of tissue paper with a hole in the middle. Sli... Dans le forum Others (Archive)	il y a 8 years
	It does find the first 3 calibration points, but not the fou... Dans le forum Others (Archive)	il y a 8 years
	You need to run/print v2calibration.gcode. It is on the SD ... Dans le forum Software (Archive)	il y a 8 years

Page 31 / 31 Précédent

Statistiques du forum

559 Forums

62.9 K Sujets

442.9 K Messages

18 En-ligne

67.7 K Membres

Le dernier des messages: PrusaConnect camera with raspberry pi + curl Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé