|
Auto Arrange seed change In forum Hardware, firmware and software help |
5 years ago |
|
my version of hard mount\lockdown feet for the MK3 In forum User mods - OctoPrint, enclosures, nozzles, ... |
6 years ago |
|
Nice Contact reference! In forum User mods - OctoPrint, enclosures, nozzles, ... |
6 years ago |
|
Try mesh mixer...it creates supports you can customize and t... In forum Hardware, firmware and software help |
6 years ago |
|
I received my MK3 yesterday. It was a pre-built unit and I ... In forum Others (Archive) |
6 years ago |
|
without insulation it might not be "hot" enough with passive... In forum Others (Archive) |
6 years ago |
|
throw a cheap thermometer in there when printing and see wha... In forum Others (Archive) |
6 years ago |
|
support told me 50x50x70 cm including the spool holder with ... In forum Others (Archive) |
6 years ago |
|
I am not going to cancel.... thanks for the input everyone.
... In forum Others (Archive) |
6 years ago |
|
I ordered mine 2/8/2018 and am due to receive it March 19-26... In forum Improvements (Archive) |
6 years ago |
|
Thanks!
Andy In forum General discussion, announcements and releases |
6 years ago |
|
I built a frame out of wood and used foam panels for 3 side.... In forum Improvements (Archive) |
6 years ago |
|
Can you post a link for #SLabPrint? I googled that but had ... In forum General discussion, announcements and releases |
6 years ago |
|
Can you post a link for #SLabPrint? I googled that but had ... In forum General discussion, announcements and releases |
6 years ago |
|
i don't have my MK3 yet but when I print ABS i don't have th... In forum Others (Archive) |
6 years ago |
|
I went the LACK enclosure route... and it was shit... for st... In forum Others (Archive) |
6 years ago |
|
Thanks a lot for the feedback. I am don't really need all t... In forum Others (Archive) |
6 years ago |
|
I don’t plan on active heating as I have a smaller printrbot... In forum Others (Archive) |
6 years ago |
|
I am waiting for my printer until i get the front door on...... In forum Others (Archive) |
6 years ago |
|
Thanks for the advice!
Andy In forum Others (Archive) |
6 years ago |
