Prusa3D Forum

Notifications

Clear all

moyashii98

Groupe: Enregistré

A(ont) rejoint: 2022/08/04

Active Member

	Apologies for the late reply. Thank you very much to both of... Dans le forum PrusaSlicer	il y a 2 years
	I really appreciate your insight. As you said, silk PLA is ... Dans le forum PrusaSlicer	il y a 2 years
	Hello again, I printed the z height gcode file that you prov... Dans le forum PrusaSlicer	il y a 2 years
	@fuchsr thank you for the links. That print does look a lot ... Dans le forum PrusaSlicer	il y a 2 years
	Thanks for the reply. I see... Definitely is hard for me to... Dans le forum PrusaSlicer	il y a 2 years
	@Swiss_Cheese, I recognize that you and @Diem have a lot of ... Dans le forum PrusaSlicer	il y a 2 years
	I didn't know the Prusa forum gave out points for attitude? ... Dans le forum PrusaSlicer	il y a 2 years
	Hello again, Thank you all for the responses. I understand t... Dans le forum PrusaSlicer	il y a 2 years
	I forgot to ask but do you see any apparent signs of under/o... Dans le forum PrusaSlicer	il y a 2 years
	Hello, thank you for the reply. On this print I did not liv... Dans le forum PrusaSlicer	il y a 2 years
	Thanks for the reply. So far I have printed two of the frog... Dans le forum PrusaSlicer	il y a 2 years
	Artifacts in Print? Looking for Guidance Dans le forum PrusaSlicer	il y a 2 years

Statistiques du forum

565 Forums

63.7 K Sujets

447 K Messages

21 En-ligne

69.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé