Prusa3D Forum

Notifications

Clear all

moTo

Skupina: Registrovaný

Přidal se: 2022/07/12

New Member

	Weird gaps in prints, nozzle or settings problem? In forum Hardware, firmware and software help	před 3 years
	Another addon: Apparently, I suck at soldering. I just did i... In forum Hardware, firmware and software help	před 3 years
	Addon: I just checked with a multimeter that the voltage bet... In forum Hardware, firmware and software help	před 3 years
	RPI Port dead? Raspberry Pi Zero 2W is not powered anymore In forum Hardware, firmware and software help	před 3 years

Fórum Statistiky

585 Fóra

68 K Témata

476.4 K Příspěvky

10 Online

75.6 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed