Prusa3D Forum

Notifications

Clear all

moses.w

Group: Registered

Joined: 2017/06/23

Active Member

	I just tried printing with the fan completely OFF. I again ... In forum Assembly and first prints troubleshooting	6 years ago
	I just performed a PID calibration following this post: . E... In forum Assembly and first prints troubleshooting	6 years ago
	New printer assembly (MK3s) - thermal runaway In forum Assembly and first prints troubleshooting	6 years ago
	This picture shows how the print shifted about 0.5cm halfway... In forum Hardware, firmware and software help	6 years ago
	X calibration messes up part way through large print - shift... In forum Hardware, firmware and software help	6 years ago
	I turned up the supply voltage so that the heatbed measured ... In forum Others (Archive)	8 years ago
	Thanks. I'll try increasing the PSU supply voltage and see ... In forum Others (Archive)	8 years ago
	Heatbed - takes long to heat, temp drops, thermal runaway In forum Others (Archive)	8 years ago

Forum Statistics

585 Forums

68.1 K Topics

477 K Posts

14 Online

75.8 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed