Prusa3D Forum

Notifications

Clear all

MNKid

Groupe: Enregistré

A(ont) rejoint: 2017/01/05

Eminent Member

	That's great to hear bud! Im really happy you got it fixed!... Dans le forum Others (Archive)	il y a 6 years
	I think i found the source, anyone with the same issue pleas... Dans le forum Others (Archive)	il y a 7 years
	I bought two new Prusa i3 mk2. One was calibrated pretty go... Dans le forum Others (Archive)	il y a 7 years
	I raised the PINDA probe and the nozzle can now touch the be... Dans le forum Others (Archive)	il y a 7 years
	did you ever find the problem and solutuon to this? Dans le forum Others (Archive)	il y a 7 years
	Have you tried raising your pinda probe slightly? Sometimes... Dans le forum Others (Archive)	il y a 7 years
	Just a quick question. Are most of the prints you have done... Dans le forum Others (Archive)	il y a 7 years
	These are all pure guesses lol. But I would double check th... Dans le forum Others (Archive)	il y a 7 years
	im so happy to hear this is helping folks. it may not be th... Dans le forum Others (Archive)	il y a 7 years
	You're welcome! I'm glad this worked for you! I spent a lo... Dans le forum Others (Archive)	il y a 7 years
	The heated bed can only be, well heated. If you set it to 1... Dans le forum Others (Archive)	il y a 7 years
	did you find the source of the issue? Dans le forum Others (Archive)	il y a 8 years
	I had similar issues where the motor would run but I couldn'... Dans le forum Others (Archive)	il y a 8 years
	That's great! I'm glad it helped out at least one person! ha... Dans le forum Others (Archive)	il y a 8 years
	As mentioned PEI sheets are great to have spares of and I gu... Dans le forum Others (Archive)	il y a 8 years
	Not exactly related to power to the Rambo, but I did have an... Dans le forum Others (Archive)	il y a 8 years
	Not exactly related to power to the Rambo, but I did have an... Dans le forum Others (Archive)	il y a 8 years
	Prusa has a link to all the printable parts on their site. ... Dans le forum Others (Archive)	il y a 8 years
	Z axis threaded rod alignment and possible solution to z axi... Dans le forum Others (Archive)	il y a 8 years
	Have the same Z axis noise. Is there a possibility to reduce... Dans le forum Prusa i3 kit (Archive)	il y a 8 years

Page 1 / 2 Suivant

Statistiques du forum

565 Forums

64.5 K Sujets

451.8 K Messages

20 En-ligne

71.1 K Membres

Le dernier des messages: PA/Nylon build plate Notre nouveau membre: baztm Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé