|
You may already know this, but in general a chamfer is bette... In forum PrusaSlicer |
10 months ago |
|
Check your max volumetric flow rate. There’s one under fila... In forum PrusaSlicer |
1 year ago |
|
Were you using Arachne or pressure advance? I would guess t... In forum PrusaSlicer |
1 year ago |
|
You didn’t mention what printer you have, but here’s how it’... In forum PrusaSlicer |
1 year ago |
|
Just add an M92 command in your start gcode with the desired... In forum PrusaSlicer |
2 years ago |
|
This is correct, as evidenced by the practice of heating a p... In forum PrusaSlicer |
2 years ago |
|
How could you know that from just the slicer image? I don’t... In forum PrusaSlicer |
2 years ago |
|
This definitely makes the most sense if the strength require... In forum PrusaSlicer |
2 years ago |
|
I’m very interested in following this. I’ve had similar fla... In forum PrusaSlicer |
2 years ago |
|
Did your purchase agreement allow you to provide his/her wor... In forum PrusaSlicer |
2 years ago |
|
Assuming you have your esteps set correctly, your filament i... In forum PrusaSlicer |
2 years ago |
|
I'm on 2.5. I upgraded to 2.5 for the new features it provi... In forum PrusaSlicer |
2 years ago |
|
Feature request - line drawing tool for painting seam enforc... In forum PrusaSlicer |
2 years ago |
|
Looks like success this evening! z travel = 12 mm/s was stil... In forum PrusaSlicer |
3 years ago |
|
Thanks, Neophyl. I'm at work now so I'll check later this e... In forum PrusaSlicer |
3 years ago |
|
As requested.
z-axis test files In forum PrusaSlicer |
3 years ago |
|
As requested. Highlighted text is what is in my start G-cod... In forum PrusaSlicer |
3 years ago |
|
I thought you might be on to something, but now I'm not sure... In forum PrusaSlicer |
3 years ago |
|
IDK the answer to this, but it is something I could try. In forum PrusaSlicer |
3 years ago |
|
My accelerations are actually set to about 1/2 of the machin... In forum PrusaSlicer |
3 years ago |
