Notifications
Clear all
mjkoenig
Skupina: Registrovaný
Přidal se: 2020/12/12
Active Member
1
|
Hi, The rod damage was the culprit of the printing issues. I... In forum Hardware, firmware and software help |
před 4 years | |
|
I'll try this when I get around to it. I am pretty sure I as... In forum Hardware, firmware and software help |
před 4 years | |
|
Gaps in printing In forum Hardware, firmware and software help |
před 4 years | |
|
Well, the solution in the support section was basically "res... In forum Hardware, firmware and software help |
před 5 years | |
|
Firmware flash issue, now stuck at logo screen In forum Hardware, firmware and software help |
před 5 years | |
| Hi, As an update: The issue I had is the same as yours. Duri... | před 5 years | |
| End of spool gets stuck in extruder | před 5 years |