Notifications
Clear all
mjkoenig
Group: Registered
Joined: 2020/12/12
Active Member
1
|
Hi, The rod damage was the culprit of the printing issues. I... In forum Hardware, firmware and software help |
4 years ago | |
|
I'll try this when I get around to it. I am pretty sure I as... In forum Hardware, firmware and software help |
4 years ago | |
|
Gaps in printing In forum Hardware, firmware and software help |
4 years ago | |
|
Well, the solution in the support section was basically "res... In forum Hardware, firmware and software help |
5 years ago | |
|
Firmware flash issue, now stuck at logo screen In forum Hardware, firmware and software help |
5 years ago | |
| Hi, As an update: The issue I had is the same as yours. Duri... | 5 years ago | |
| End of spool gets stuck in extruder | 5 years ago |