Prusa3D Forum

Notifiche

Cancella tutti

Miniatureminit

Gruppo: Registrato

Registrato: 2018/02/13

Active Member

	Yes, thats the same settings. Nel forum Hardware, firmware and software help	6 years fa
	Yes i changed the profile to 0.6 Nozzle, but used default se... Nel forum Hardware, firmware and software help	6 years fa
	Hi. Dont know if this is the thread to take this up. But ... Nel forum Hardware, firmware and software help	6 years fa
	Hi. Got some new filament (PETG) and the extruder started ... Nel forum Hardware, firmware and software help	7 years fa
	i have tested with everything from 205 to 225C, and i dont n... Nel forum Hardware, firmware and software help	7 years fa
	Yesterday i got a filament sampel that is 1,64 to 1,69mm in ... Nel forum Hardware, firmware and software help	7 years fa
	Hi . Have the same problem but only with the Prusa supplied... Nel forum Hardware, firmware and software help	7 years fa
	Mine shiped today, ordered 12/2 an orange kit. Nel forum General discussion, announcements and releases	7 years fa
	Also going crazy over this... Ordered 12/2-18 support toald ... Nel forum General discussion, announcements and releases	7 years fa

Statistiche Forum

565 Forum

63.8 K Discussioni

447.3 K Post

23 Online

69.3 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso