miles-h2 – Activité – Prusa3D Forum

Notifications

Clear all

miles-h2

Groupe: Enregistré

A(ont) rejoint: 2018/12/15

Eminent Member

	I have tried several times to upload the 3mf file ( thanks f... Dans le forum Hardware, firmware and software help	il y a 6 years
	Bobstro: I increased the length to 4.0 but I did not s=chang... Dans le forum Hardware, firmware and software help	il y a 6 years
	tim-m30: What is a 3mf file? How do I load it for you to see... Dans le forum Hardware, firmware and software help	il y a 6 years
	I moved the "O" scale insulators to a 1" OC spacing to try t... Dans le forum Hardware, firmware and software help	il y a 6 years
	Retraction Dans le forum Hardware, firmware and software help	il y a 6 years
	All is well that ends well. After doing a second first level... Dans le forum How do I print this? (Printing help)	il y a 7 years
	Did a first layer adjustment and it seems to be working so f... Dans le forum How do I print this? (Printing help)	il y a 7 years
	Just checked and it showed-1.122 Dans le forum How do I print this? (Printing help)	il y a 7 years
	I think the last was 1.54. I tried setting the Z on the fly ... Dans le forum How do I print this? (Printing help)	il y a 7 years
	Prints will not stick to the steel bed Dans le forum How do I print this? (Printing help)	il y a 7 years

Page 2 / 2 Précédent

Statistiques du forum

595 Forums

69.2 K Sujets

484 K Messages

14 En-ligne

78.3 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé