Notifications
Clear all
mikeolson
Skupina: Registrovaný
Přidal se: 2023/01/23
Active Member
1
|
The printer does preheat before unload, but I still occasion... In forum Hardware, firmware and software help |
před 2 years | |
|
Closing this item out: The problem was indeed a bit of broke... In forum Hardware, firmware and software help |
před 2 years | |
|
I got the printer disassembled and pulled some gunk out of t... In forum Hardware, firmware and software help |
před 2 years | |
|
Repeated filament breaks inside the hotend PTFE tube In forum Hardware, firmware and software help |
před 2 years | |
|
Thanks, guys. I tried @jsw's trick to try to melt the blocka... In forum Hardware, firmware and software help |
před 2 years | |
|
Can't load filament In forum Hardware, firmware and software help |
před 2 years | |
| Just closing this topic out: The problem was a bad Z configu... | před 2 years | |
| Thanks, Karl-Herbert. In case anyone else finds their way to... | před 2 years | |
| Hey @JoanTabb, thanks for the thorough explanation and for t... | před 2 years | |
| Part warping on bed during print? | před 2 years |