Avisos
Vaciar todo
Mike_wth
Mike_wth
Grupo: Registrado
Registrado: 2018/02/06
Active Member
1
Hi Fabian The thread is interesting, but not really necessar...

En el foro How do I print this? (Printing help)

hace 6 years
I tried PETG/PLA. They are perfect as support for each other...

En el foro How do I print this? (Printing help)

hace 6 years
Hi Carsten, I never had adhesion problems to the heatbed. Fo...

En el foro How do I print this? (Printing help)

hace 6 years
For printing PETG I use the bed temperature for PETG. I woul...

En el foro How do I print this? (Printing help)

hace 6 years
Hey guys, next update: I tried different settings with Prusa...

En el foro How do I print this? (Printing help)

hace 6 years
Thanks Vojtech! I learned something 😉 Short update:I tried...

En el foro How do I print this? (Printing help)

hace 6 years
It's a pain. I'm working on it.... Not right there, but step...

En el foro General discussion, announcements and releases

hace 6 years
Hey Guys, one more hint for the fight against impurities:Dur...

En el foro How do I print this? (Printing help)

hace 6 years
Hey Guys, two more learnings from today's prints. All about ...

En el foro How do I print this? (Printing help)

hace 6 years
Hi Guys, In general:I had to go through a LOT of learnings a...

En el foro How do I print this? (Printing help)

hace 6 years
(Soluble) Support for PETG - Full interface layer

En el foro How do I print this? (Printing help)

hace 6 years
Thanks a lot guys. I think I'll start with a cheap ripoff Ra...

En el foro User mods - OctoPrint, enclosures, nozzles, ...

hace 6 years
Can't help with the new surface as well. However, I also thi...

En el foro User mods - OctoPrint, enclosures, nozzles, ...

hace 6 years
Raspberry camera angle

En el foro User mods - OctoPrint, enclosures, nozzles, ...

hace 6 years
Compartir: