Notifications
Clear all
Mike_wth
Mike_wth
Group: Registered
Joined: 2018/02/06
Active Member
1
Hi Fabian The thread is interesting, but not really necessar...

In forum How do I print this? (Printing help)

6 years ago
I tried PETG/PLA. They are perfect as support for each other...

In forum How do I print this? (Printing help)

6 years ago
Hi Carsten, I never had adhesion problems to the heatbed. Fo...

In forum How do I print this? (Printing help)

6 years ago
For printing PETG I use the bed temperature for PETG. I woul...

In forum How do I print this? (Printing help)

6 years ago
Hey guys, next update: I tried different settings with Prusa...

In forum How do I print this? (Printing help)

6 years ago
Thanks Vojtech! I learned something 😉 Short update:I tried...

In forum How do I print this? (Printing help)

6 years ago
It's a pain. I'm working on it.... Not right there, but step...

In forum General discussion, announcements and releases

6 years ago
Hey Guys, one more hint for the fight against impurities:Dur...

In forum How do I print this? (Printing help)

6 years ago
Hey Guys, two more learnings from today's prints. All about ...

In forum How do I print this? (Printing help)

6 years ago
Hi Guys, In general:I had to go through a LOT of learnings a...

In forum How do I print this? (Printing help)

6 years ago
(Soluble) Support for PETG - Full interface layer

In forum How do I print this? (Printing help)

6 years ago
Thanks a lot guys. I think I'll start with a cheap ripoff Ra...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Can't help with the new surface as well. However, I also thi...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Raspberry camera angle

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Share: