|
Belt tuning success Nel forum Hardware, firmware and software help |
1 month fa |
|
I'm sorry not to have responded before. Yes, that does indic... Nel forum Assembly and first prints troubleshooting |
2 months fa |
|
Thanks, Martin. You will see I have resolved the issue for m... Nel forum Assembly and first prints troubleshooting |
2 months fa |
|
I have resolved my issue by rethinking the gantry assembly p... Nel forum Assembly and first prints troubleshooting |
2 months fa |
|
@martinf did you ever get a resolution to this issue? I have... Nel forum Assembly and first prints troubleshooting |
2 months fa |
|
Thanks for the replies. It is what I suspected but I hope th... Nel forum Hardware, firmware and software help |
11 months fa |
|
MK4S IS configuration Nel forum Hardware, firmware and software help |
11 months fa |
|
Thanks for your detailed response. I could have remodelled t... Nel forum PrusaSlicer |
1 year fa |
|
So shared links don't work either! I'll go back to school.😉 ... Nel forum PrusaSlicer |
1 year fa |
|
So shared links don't work either! I'll go back to school.😉 ... Nel forum PrusaSlicer |
1 year fa |
|
The project file 'pinion.3mf' is attached here Nel forum PrusaSlicer |
1 year fa |
|
Supports to model interface Nel forum PrusaSlicer |
1 year fa |
|
Supports to model interface Nel forum PrusaSlicer |
1 year fa |
|
I've done two full bed prints and several short corner print... Nel forum Hardware, firmware and software help |
2 years fa |
|
I wanted not to have to resort to that, but I'll do it. At l... Nel forum Assembly and first prints troubleshooting |
2 years fa |
|
Sadly, I went to Live Chat today with the issue and all I go... Nel forum Assembly and first prints troubleshooting |
2 years fa |
|
Sadly, it doesn't "feel" correctly, as it only tests once at... Nel forum Hardware, firmware and software help |
2 years fa |
|
It's a kit and the bed is perfectly flat in both X, Y and di... Nel forum Assembly and first prints troubleshooting |
2 years fa |
|
I had no issues with this, and everything clears with no int... Nel forum Assembly and first prints troubleshooting |
2 years fa |
|
Poor adhesion on textured plate Nel forum Assembly and first prints troubleshooting |
2 years fa |
