|
Thanks for the replies. It is what I suspected but I hope th... In forum Hardware, firmware and software help |
2 months temu |
|
MK4S IS configuration In forum Hardware, firmware and software help |
2 months temu |
|
Thanks for your detailed response. I could have remodelled t... In forum PrusaSlicer |
7 months temu |
|
So shared links don't work either! I'll go back to school.😉 ... In forum PrusaSlicer |
7 months temu |
|
So shared links don't work either! I'll go back to school.😉 ... In forum PrusaSlicer |
7 months temu |
|
The project file 'pinion.3mf' is attached here In forum PrusaSlicer |
7 months temu |
|
Supports to model interface In forum PrusaSlicer |
7 months temu |
|
Supports to model interface In forum PrusaSlicer |
7 months temu |
|
I've done two full bed prints and several short corner print... In forum Hardware, firmware and software help |
1 year temu |
|
I wanted not to have to resort to that, but I'll do it. At l... In forum Assembly and first prints troubleshooting |
1 year temu |
|
Sadly, I went to Live Chat today with the issue and all I go... In forum Assembly and first prints troubleshooting |
1 year temu |
|
Sadly, it doesn't "feel" correctly, as it only tests once at... In forum Hardware, firmware and software help |
1 year temu |
|
It's a kit and the bed is perfectly flat in both X, Y and di... In forum Assembly and first prints troubleshooting |
1 year temu |
|
I had no issues with this, and everything clears with no int... In forum Assembly and first prints troubleshooting |
1 year temu |
|
Poor adhesion on textured plate In forum Assembly and first prints troubleshooting |
1 year temu |
|
@swiss_cheese Thanks. Yes, I knew that and had shifted the t... In forum How do I print this? (Printing help) |
4 years temu |
|
Prusament Galaxy Black delamination In forum How do I print this? (Printing help) |
4 years temu |
|
@tim-m30 Thanks Tim In forum Improvements (Archive) |
5 years temu |
|
@tim-m30 Yes, my comment was to point to the issue but I lik... In forum Improvements (Archive) |
5 years temu |
|
As @bobstro and @guy-k2 indicate the issue is due to the sta... In forum Improvements (Archive) |
5 years temu |
