|
Belt tuning success In forum Hardware, firmware and software help |
1 month ago |
|
I'm sorry not to have responded before. Yes, that does indic... In forum Assembly and first prints troubleshooting |
2 months ago |
|
Thanks, Martin. You will see I have resolved the issue for m... In forum Assembly and first prints troubleshooting |
2 months ago |
|
I have resolved my issue by rethinking the gantry assembly p... In forum Assembly and first prints troubleshooting |
2 months ago |
|
@martinf did you ever get a resolution to this issue? I have... In forum Assembly and first prints troubleshooting |
2 months ago |
|
Thanks for the replies. It is what I suspected but I hope th... In forum Hardware, firmware and software help |
11 months ago |
|
MK4S IS configuration In forum Hardware, firmware and software help |
11 months ago |
|
Thanks for your detailed response. I could have remodelled t... In forum PrusaSlicer |
1 year ago |
|
So shared links don't work either! I'll go back to school.😉 ... In forum PrusaSlicer |
1 year ago |
|
So shared links don't work either! I'll go back to school.😉 ... In forum PrusaSlicer |
1 year ago |
|
The project file 'pinion.3mf' is attached here In forum PrusaSlicer |
1 year ago |
|
Supports to model interface In forum PrusaSlicer |
1 year ago |
|
Supports to model interface In forum PrusaSlicer |
1 year ago |
|
I've done two full bed prints and several short corner print... In forum Hardware, firmware and software help |
2 years ago |
|
I wanted not to have to resort to that, but I'll do it. At l... In forum Assembly and first prints troubleshooting |
2 years ago |
|
Sadly, I went to Live Chat today with the issue and all I go... In forum Assembly and first prints troubleshooting |
2 years ago |
|
Sadly, it doesn't "feel" correctly, as it only tests once at... In forum Hardware, firmware and software help |
2 years ago |
|
It's a kit and the bed is perfectly flat in both X, Y and di... In forum Assembly and first prints troubleshooting |
2 years ago |
|
I had no issues with this, and everything clears with no int... In forum Assembly and first prints troubleshooting |
2 years ago |
|
Poor adhesion on textured plate In forum Assembly and first prints troubleshooting |
2 years ago |
