|
If you don’t use USB how do you connect your Pi to the MK4? In forum User mods - OctoPrint, enclosures, nozzles, ... |
1 year ago |
|
The UPS is 400 VA. It resets fine if I do not attempt to us... In forum User mods - OctoPrint, enclosures, nozzles, ... |
1 year ago |
|
I connected my RPi to the MK4 via the USB-C connector, and O... In forum User mods - OctoPrint, enclosures, nozzles, ... |
1 year ago |
|
Thank you. This morning I showed it to a friend and he imme... In forum How do I print this? (Printing help) |
2 years ago |
|
PETG on large surface prints In forum How do I print this? (Printing help) |
2 years ago |
|
Thanks. Prusament Urban Grey. The live Z has been set up ... In forum How do I print this? (Printing help) |
2 years ago |
|
My Z offset is -0.620. Forgive me for ignorance, but is goi... In forum How do I print this? (Printing help) |
2 years ago |
|
Here is photo . In forum How do I print this? (Printing help) |
2 years ago |
|
There is no filament coming down from the top of the heat bl... In forum How do I print this? (Printing help) |
2 years ago |
|
New nozzle (probably not necessary since the old one looked ... In forum Hardware, firmware and software help |
2 years ago |
|
Here is the second picture.
IMG_6731.jpeg In forum How do I print this? (Printing help) |
2 years ago |
|
PETG Globs on Print In forum How do I print this? (Printing help) |
2 years ago |
|
Problem resumed, unable to print anything. Either no adhesi... In forum Hardware, firmware and software help |
2 years ago |
|
I did not change the nozzle. I also discovered that it is no... In forum Hardware, firmware and software help |
2 years ago |
|
This was also done and coincided with beginning to get succe... In forum Hardware, firmware and software help |
2 years ago |
|
I finally just got the z live adjustment corrected. Printin... In forum Hardware, firmware and software help |
2 years ago |
|
I did factory reset and went through entire wizard without a... In forum Hardware, firmware and software help |
2 years ago |
|
While I have printed for over 18 months, very sporadic. Tot... In forum Hardware, firmware and software help |
2 years ago |
|
Clumping and nothing printing - PETG and PLA In forum Hardware, firmware and software help |
2 years ago |
