Prusa3D Forum

Notifications

Clear all

Mike

Skupina: Registrovaný

Přidal se: 2017/09/25

Active Member

	@joerg-e Unfortunately I have had to set the project aside. ... In forum Assembly and first prints troubleshooting	před 5 years
	OP here. u-bolts checked and are not too tight. Also release... In forum Assembly and first prints troubleshooting	před 5 years
	bed not level - mesh bed leveling does not compenstate In forum Assembly and first prints troubleshooting	před 5 years
	Is firmware flashed the same way as the MK3s - ie, using Pru... In forum General discussion, announcements and releases	před 5 years
	@pjr Confirmed, that was the issue. I was able to keep one t... In forum Assembly and first prints troubleshooting	před 5 years
	@pjr File is simply lid.gcode - but it is in several subdire... In forum Assembly and first prints troubleshooting	před 5 years
	Print from USB drive wont start In forum Assembly and first prints troubleshooting	před 5 years
	Here is my take on spool holding - I built a custom shelf wi... In forum General discussion, announcements and releases	před 6 years
	"Do you think they will find the hidden stuff here?&quo... In forum General discussion, announcements and releases	před 6 years

Fórum Statistiky

559 Fóra

63.1 K Témata

444 K Příspěvky

26 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed