Prusa3D Forum

Notifications

Clear all

Mike

Group: Registered

Joined: 2017/09/25

Active Member

	@joerg-e Unfortunately I have had to set the project aside. ... In forum Assembly and first prints troubleshooting	5 years ago
	OP here. u-bolts checked and are not too tight. Also release... In forum Assembly and first prints troubleshooting	5 years ago
	bed not level - mesh bed leveling does not compenstate In forum Assembly and first prints troubleshooting	5 years ago
	Is firmware flashed the same way as the MK3s - ie, using Pru... In forum General discussion, announcements and releases	5 years ago
	@pjr Confirmed, that was the issue. I was able to keep one t... In forum Assembly and first prints troubleshooting	5 years ago
	@pjr File is simply lid.gcode - but it is in several subdire... In forum Assembly and first prints troubleshooting	5 years ago
	Print from USB drive wont start In forum Assembly and first prints troubleshooting	5 years ago
	Here is my take on spool holding - I built a custom shelf wi... In forum General discussion, announcements and releases	6 years ago
	"Do you think they will find the hidden stuff here?&quo... In forum General discussion, announcements and releases	6 years ago

Forum Statistics

559 Forums

63 K Topics

443.6 K Posts

21 Online

67.9 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed