Mike – Activité – Prusa3D Forum

Notifications

Clear all

Mike

Groupe: Enregistré

A(ont) rejoint: 2020/05/11

Trusted Member

	@evanhovorka To add to Andrew's advice, I have only used hot... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	I spent most of my weekend printing with PC-ABS, so having t... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Posted by: @andrewld If I ask very nicely can I have your e... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	@evanhovorka Do a search of the forum for Life-Z. In that po... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	@rhdreambox I have printed this in PC-ABS(for greater heat h... Dans le forum General discussion, announcements and releases	il y a 4 years
	Mine was ordered April 16th and it arrived Tuesday he 26th o... Dans le forum General discussion, announcements and releases	il y a 4 years
	Mine said the same thing and it shipped when it was supposed... Dans le forum General discussion, announcements and releases	il y a 4 years
	@joantabb Thanks for the advice I’ll look into an upgraded i... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	My only complaint is that there doesn’t seem to be any cente... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	New printer fun to build. Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	There is Prusament on Amazon but it’s $70-80 For a 1kg roll ... Dans le forum General discussion, announcements and releases	il y a 5 years

Page 3 / 3 Précédent

Statistiques du forum

559 Forums

63.1 K Sujets

443.9 K Messages

23 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé