Čeština
Fóra
Uživatelé
MightWorks
Aktivita
 
Notifications
Clear all
MightWorks
MightWorks
Skupina: Registrovaný
Přidal se: 2020/08/28
Eminent Member
2
Profile Aktivita
Oozing is ruining my TPU gasket, anyway I can optimize this ...

In forum How do I print this? (Printing help)

 před 4 years
Yep you're correct! I realized the defect was always happeni...

In forum How do I print this? (Printing help)

 před 4 years
Any ideas on this nasty scar (non z-seam)?

In forum How do I print this? (Printing help)

 před 4 years
Hi all, Sorry to revive an old thread, hoping I can get some...

In forum Assembly and first prints troubleshooting

 před 5 years
So I've done more research and have found examples of people...

In forum Hardware, firmware and software help

 před 5 years
Asymmetrical (and messy) circles

In forum Hardware, firmware and software help

 před 5 years
Imperfect circles, in desperate need of help!

In forum How do I print this? (Printing help)

 před 5 years
@jsw Thank you! This is really helpful. I'll make the adjust...

In forum How do I print this? (Printing help)

 před 5 years
Strange shifting behavior--any ideas?

In forum Assembly and first prints troubleshooting

 před 5 years
Super frustrated with anything ABS. Any tips?

In forum How do I print this? (Printing help)

 před 5 years
Thanks both. I did try to align the seam, and it did align b...

In forum How do I print this? (Printing help)

 před 5 years
Strange artifacts in print, any ideas?

In forum How do I print this? (Printing help)

 před 5 years
Stránka 2 / 2
Share: