Activity
 
Notifications
Clear all
Mifpe
Mifpe
Group: Registered
Joined: 2018/11/23
Active Member
1
Just to pitch in. I recently got a PiZero2W where using GPIO...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Just a quick update.. I tried flashing the pi with 0.7.0.RC1...

In forum Introduction & Instructions

2 years ago
I am sorry that I am keeping you occupied with this. I teste...

In forum Introduction & Instructions

2 years ago
First off, I wanna thank you for taking the time to help on ...

In forum Introduction & Instructions

2 years ago
So, I got a hold of an otg adapter and set it up as describe...

In forum Introduction & Instructions

2 years ago
Thank you for the help so far. I will get an otg adapter lat...

In forum Introduction & Instructions

2 years ago
Hello Tojik I used the new image for the PI and also reflash...

In forum Introduction & Instructions

2 years ago
Hello Tojik I don't know which version it is. I am using the...

In forum Introduction & Instructions

2 years ago
Sorry for necroing this thread. I have the exact same error ...

In forum Introduction & Instructions

2 years ago
I know it has been 3 years since an update to this problem, ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
@dan-rogers Sounds great, I will look into the solution with...

In forum Hardware, firmware and software help

4 years ago
@diem I tried loosening the screws a bit and lubricating the...

In forum Hardware, firmware and software help

4 years ago
@bascule Yesterday I bought a 40x40x5cm concrete tile (18kg)...

In forum Hardware, firmware and software help

4 years ago
@diem It looks straight. I did however notice that the top r...

In forum Hardware, firmware and software help

4 years ago
@dan-rogers I will definitely check this out. I have always ...

In forum Hardware, firmware and software help

4 years ago
@diem It doesn't feel any different than touching other part...

In forum Hardware, firmware and software help

4 years ago
@friedhelm-b Thank you for the quick reply. A good suggestio...

In forum Hardware, firmware and software help

4 years ago
Help on noise

In forum Hardware, firmware and software help

4 years ago
My new MK3 kit also has this annoying print fan noise when p...

In forum Others (Archive)

6 years ago
Share: