Čeština
Fóra
Uživatelé
mick
Aktivita
 
Notifications
Clear all
mick
mick
Skupina: Registrovaný
Přidal se: 2017/08/29
Active Member
1
Profile Aktivita
Printing with colorfabb cork- How to make it look wooden?

In forum Print tips (Archive)

 před 7 years
And here is the vertical print. It looks perfect except for ...

In forum Prusa i3 kit (Archive)

 před 7 years
I am printing a 100mm high tube as we speak to test the vert...

In forum Prusa i3 kit (Archive)

 před 7 years
Test print and more experienced advice wanted

In forum Prusa i3 kit (Archive)

 před 7 years
The distance each axis travels is controlled by the steps pe...

In forum Prusa i3 kit (Archive)

 před 7 years
Assuming you are using Slic3r, check out: Print Settings -&...

In forum Prusa i3 kit (Archive)

 před 7 years
Fine tuning print sizes on mk2s

In forum Prusa i3 kit (Archive)

 před 7 years
I believe mine was just a bad bearing and went out, as for ...

In forum Improvements (Archive)

 před 7 years
Sounds like a bearing is going out, I had one do it to me af...

In forum Improvements (Archive)

 před 7 years
Y axis bearing mounting mod MK2s- Rods scored

In forum Improvements (Archive)

 před 7 years
I suspect that is the case as i installed it pretty much fro...

In forum Others (Archive)

 před 7 years
Brilliant Thanks for the help. Exactly what i needed to hea...

In forum Others (Archive)

 před 7 years
Mk2s leaking above the ally ext block

In forum Others (Archive)

 před 7 years
I have just had a go on freecad and i find it even worse hah...

In forum Software (Archive)

 před 7 years
Preferred drawing software

In forum Software (Archive)

 před 7 years
Thanks for the advice im looking forward to using something...

In forum Others (Archive)

 před 7 years
i3 Mk2s shopping list and software advice

In forum Others (Archive)

 před 7 years
Share: