Prusa3D Forum

Notifications

Clear all

michael.h33

Groupe: Enregistré

A(ont) rejoint: 2017/10/03

Active Member

	Beeping sound? Dans le forum Others (Archive)	il y a 7 years
	Thanks everyone for your help I fixed it and now its printin... Dans le forum Others (Archive)	il y a 7 years
	The directions say to take it off, but when its finding the ... Dans le forum Others (Archive)	il y a 7 years
	the first time I had the printer calibrate Z the X axis rods... Dans le forum Others (Archive)	il y a 7 years
	3.1.1 -rc4 b143 is out now... for the Mk3 and also a new dri... Dans le forum Others (Archive)	il y a 7 years
	The cable is not super tight, if I press the top it’s easy f... Dans le forum Others (Archive)	il y a 7 years
	Heres a video maybe this will help, ] Dans le forum Others (Archive)	il y a 7 years
	Your pinda probe is positioned too low. You really need to f... Dans le forum Others (Archive)	il y a 7 years
	I think I found my problem, when the Z is calibrating and go... Dans le forum Others (Archive)	il y a 7 years
	i put a sheet of writing paper on the bed and gently lowered... Dans le forum Others (Archive)	il y a 7 years
	The second picture looks like the PINDA-Probe is mounted dee... Dans le forum Others (Archive)	il y a 7 years
	The hotend isn't touching the bed in the picture you posted.... Dans le forum Others (Archive)	il y a 7 years
	Calibration Error Dans le forum Others (Archive)	il y a 7 years

Statistiques du forum

565 Forums

63.5 K Sujets

445.6 K Messages

20 En-ligne

68.7 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé