Prusa3D Forum

Notifications

Clear all

michael.f3

Groupe: Enregistré

A(ont) rejoint: 2016/05/03

Eminent Member

	I was having a similar problem with windows 10 yesterday. I... Dans le forum Print tips (Archive)	il y a 7 years
	I don't think it can be purely the belts; we would have seen... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Jorge - Thanks for contributing , I've noticed the same thin... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Thanks Luis, not dumb I'll take all the help I can get. Sli... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	They've stated that they will discontinuing development of t... Dans le forum Print tips (Archive)	il y a 8 years
	What's pushing it though? The bed levelling or something els... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Pretty much just got rid of the build-up in there. It felt ... Dans le forum Others (Archive)	il y a 8 years
	I had to give that part a good clean out with a scalpel to c... Dans le forum Others (Archive)	il y a 8 years
	Thanks Kevin. So this seems to be a repeatable issue across ... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Thanks Peter, but I don't think it's worth getting too hung ... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Its PLA. IMHO its not extruder related (its not everywhere).... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	that sounds super frustrating. You're working through all t... Dans le forum Others (Archive)	il y a 8 years
	Not the models - the cube has 2 tris per face. I picked th... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	That looks pretty good to be fair. The glass topped beds I'... Dans le forum Others (Archive)	il y a 8 years
	Hi Roman, I read your page, a little bit glad that somebody... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Roman, my first prints looked like that too but it's been wo... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	vertical lines Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	We print some with PET and use a bed setting of 90 degrees, ... Dans le forum Others (Archive)	il y a 8 years
	Thanks Peter. On my older printer I use a specific nozzle ... Dans le forum Others (Archive)	il y a 8 years
	Thanks PJR, do you have to loosen any of the screws as well? Dans le forum Others (Archive)	il y a 8 years

Page 1 / 2 Suivant

Statistiques du forum

559 Forums

62.9 K Sujets

442.8 K Messages

19 En-ligne

67.6 K Membres

Le dernier des messages: Where I have to mount the GPIO board? Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé