|
I just noticed the two holes in your pipe, did they have sup... Dans le forum Hardware, firmware and software help |
il y a 2 years |
|
Up front, this next post is about printing overhangs in ABS.... Dans le forum Hardware, firmware and software help |
il y a 2 years |
|
I'll admit I've always done nozzle replacement incorrectly. ... Dans le forum How do I print this? (Printing help) |
il y a 2 years |
|
This thread really helps. I’ve got an outdoor project that ... Dans le forum How do I print this? (Printing help) |
il y a 3 years |
|
Thinking back, I've seen a few curly strings when reloading ... Dans le forum Hardware, firmware and software help |
il y a 3 years |
|
I didn't get any more burnt blob, but the same rough spots a... Dans le forum Hardware, firmware and software help |
il y a 3 years |
|
I decided this was still Blob of Doom aftermath, but if it g... Dans le forum Hardware, firmware and software help |
il y a 3 years |
|
See below for the best I've gotten using 0.005 mm steps. Th... Dans le forum Hardware, firmware and software help |
il y a 3 years |
|
I've got an underlying problem that started before the blob.... Dans le forum Hardware, firmware and software help |
il y a 3 years |
|
It worked great, the blob turned to taffy after about 10 min... Dans le forum Hardware, firmware and software help |
il y a 3 years |
|
Thanks, now I know the correct terminology. The search work... Dans le forum Hardware, firmware and software help |
il y a 3 years |
|
When a print goes really bad Dans le forum Hardware, firmware and software help |
il y a 3 years |
|
I don't understand - are we worried about the printer buildi... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
It's been a while, but I've finally gotten the number 4 LED ... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
Digging the support out of a 3mm slot is very time consuming... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Moving on, character 4 was even more interesting. Without X... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Thanks for the close look. I've tried both orientations, sl... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Edit for previous post: "It doesn't respond to XY compensati... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
That was great - setting XY compensation to 0.1mm cleaned it... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
This isn't a long-term solution, but I tried "Support on bui... Dans le forum Hardware, firmware and software help |
il y a 6 years |
