|
I just noticed the two holes in your pipe, did they have sup... En el foro Hardware, firmware and software help |
hace 2 years |
|
Up front, this next post is about printing overhangs in ABS.... En el foro Hardware, firmware and software help |
hace 2 years |
|
I'll admit I've always done nozzle replacement incorrectly. ... En el foro How do I print this? (Printing help) |
hace 2 years |
|
This thread really helps. I’ve got an outdoor project that ... En el foro How do I print this? (Printing help) |
hace 3 years |
|
Thinking back, I've seen a few curly strings when reloading ... En el foro Hardware, firmware and software help |
hace 3 years |
|
I didn't get any more burnt blob, but the same rough spots a... En el foro Hardware, firmware and software help |
hace 3 years |
|
I decided this was still Blob of Doom aftermath, but if it g... En el foro Hardware, firmware and software help |
hace 3 years |
|
See below for the best I've gotten using 0.005 mm steps. Th... En el foro Hardware, firmware and software help |
hace 3 years |
|
I've got an underlying problem that started before the blob.... En el foro Hardware, firmware and software help |
hace 3 years |
|
It worked great, the blob turned to taffy after about 10 min... En el foro Hardware, firmware and software help |
hace 3 years |
|
Thanks, now I know the correct terminology. The search work... En el foro Hardware, firmware and software help |
hace 3 years |
|
When a print goes really bad En el foro Hardware, firmware and software help |
hace 3 years |
|
I don't understand - are we worried about the printer buildi... En el foro Hardware, firmware and software help |
hace 5 years |
|
It's been a while, but I've finally gotten the number 4 LED ... En el foro Hardware, firmware and software help |
hace 5 years |
|
Digging the support out of a 3mm slot is very time consuming... En el foro Hardware, firmware and software help |
hace 6 years |
|
Moving on, character 4 was even more interesting. Without X... En el foro Hardware, firmware and software help |
hace 6 years |
|
Thanks for the close look. I've tried both orientations, sl... En el foro Hardware, firmware and software help |
hace 6 years |
|
Edit for previous post: "It doesn't respond to XY compensati... En el foro Hardware, firmware and software help |
hace 6 years |
|
That was great - setting XY compensation to 0.1mm cleaned it... En el foro Hardware, firmware and software help |
hace 6 years |
|
This isn't a long-term solution, but I tried "Support on bui... En el foro Hardware, firmware and software help |
hace 6 years |
