|
I just noticed the two holes in your pipe, did they have sup... In forum Hardware, firmware and software help |
2 years ago |
|
Up front, this next post is about printing overhangs in ABS.... In forum Hardware, firmware and software help |
2 years ago |
|
I'll admit I've always done nozzle replacement incorrectly. ... In forum How do I print this? (Printing help) |
2 years ago |
|
This thread really helps. I’ve got an outdoor project that ... In forum How do I print this? (Printing help) |
3 years ago |
|
Thinking back, I've seen a few curly strings when reloading ... In forum Hardware, firmware and software help |
3 years ago |
|
I didn't get any more burnt blob, but the same rough spots a... In forum Hardware, firmware and software help |
3 years ago |
|
I decided this was still Blob of Doom aftermath, but if it g... In forum Hardware, firmware and software help |
3 years ago |
|
See below for the best I've gotten using 0.005 mm steps. Th... In forum Hardware, firmware and software help |
3 years ago |
|
I've got an underlying problem that started before the blob.... In forum Hardware, firmware and software help |
3 years ago |
|
It worked great, the blob turned to taffy after about 10 min... In forum Hardware, firmware and software help |
3 years ago |
|
Thanks, now I know the correct terminology. The search work... In forum Hardware, firmware and software help |
3 years ago |
|
When a print goes really bad In forum Hardware, firmware and software help |
3 years ago |
|
I don't understand - are we worried about the printer buildi... In forum Hardware, firmware and software help |
5 years ago |
|
It's been a while, but I've finally gotten the number 4 LED ... In forum Hardware, firmware and software help |
5 years ago |
|
Digging the support out of a 3mm slot is very time consuming... In forum Hardware, firmware and software help |
6 years ago |
|
Moving on, character 4 was even more interesting. Without X... In forum Hardware, firmware and software help |
6 years ago |
|
Thanks for the close look. I've tried both orientations, sl... In forum Hardware, firmware and software help |
6 years ago |
|
Edit for previous post: "It doesn't respond to XY compensati... In forum Hardware, firmware and software help |
6 years ago |
|
That was great - setting XY compensation to 0.1mm cleaned it... In forum Hardware, firmware and software help |
6 years ago |
|
This isn't a long-term solution, but I tried "Support on bui... In forum Hardware, firmware and software help |
6 years ago |
