Notifications
Clear all
MetaMarkTea
Skupina: Registrovaný
Přidal se: 2023/01/04
Active Member
1
|
No enclosure. That’s good to know. The piece definitely come... In forum Hardware, firmware and software help |
před 3 months | |
|
RE: Nozzle Scraping the print as it goes In forum Hardware, firmware and software help |
před 3 months | |
|
Nozzle Scraping the print as it goes In forum Hardware, firmware and software help |
před 3 months | |
|
Oh wow, thats a lot more squished for sure! I can try going... In forum Hardware, firmware and software help |
před 2 years | |
|
Top Layer at -1.42: First Layer at -1.42: In forum Hardware, firmware and software help |
před 2 years | |
|
Lowered from -1.385 to -1.418 In forum Hardware, firmware and software help |
před 2 years | |
|
Yes, this was the first large print. The smaller test ones ... In forum Hardware, firmware and software help |
před 2 years | |
|
Its a Prusa M3KS+ Self-Assembled Kit In forum Hardware, firmware and software help |
před 2 years | |
|
Top Layer looking a little off In forum Hardware, firmware and software help |
před 2 years |