Prusa3D Forum

Notifications

Clear all

Mel

Skupina: Registrovaný

Přidal se: 2022/03/25

Active Member

	I have some cautios optimism the reason for me is humidity. ... In forum Hardware, firmware and software help	před 3 years
	So what I did was two cold pulls and there were no signs of ... In forum Hardware, firmware and software help	před 3 years
	I had exactly the same issue today thrice already. Did you f... In forum Hardware, firmware and software help	před 3 years
	Thanks for all your input! I will take my filament roll to t... In forum Assembly and first prints troubleshooting	před 3 years
	Should PETG prints look the same as PLA prints? In forum Assembly and first prints troubleshooting	před 3 years
	"Pillowing"... of course that has a name. Turned out fine wi... In forum How do I print this? (Printing help)	před 3 years
	First PETG print turned out awful In forum How do I print this? (Printing help)	před 3 years

Fórum Statistiky

585 Fóra

67.9 K Témata

475.9 K Příspěvky

11 Online

75.5 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed