Prusa3D Forum

Notifications

Clear all

Md Fo

Groupe: Enregistré

A(ont) rejoint: 2021/11/27

Active Member

	Thank you @neophyl - not pasting over the machine limits of ... Dans le forum PrusaSlicer	il y a 3 years
	@Diem - interesting. What would you propose to change concer... Dans le forum PrusaSlicer	il y a 3 years
	While I really appreciate all of your hints my main issue st... Dans le forum PrusaSlicer	il y a 3 years
	RE: Prusa Slicer possibly overextruding with 0.3mm nozzle Dans le forum PrusaSlicer	il y a 3 years
	This is Prusa Slicer (left - 2:28h print time) vs Slic3r (ri... Dans le forum PrusaSlicer	il y a 3 years
	The printer was an Ender2 but I switched the hotend to an or... Dans le forum PrusaSlicer	il y a 3 years
	Thanks! I printed the part on my other printer with the same... Dans le forum PrusaSlicer	il y a 3 years
	I reduced the small perimeter speed from 15mm/s to 5mm/s as ... Dans le forum PrusaSlicer	il y a 3 years
	@Swiss_Cheese This 7x7mm tower is just for quick tests - I g... Dans le forum PrusaSlicer	il y a 3 years
	Hey guys! I included the 3mf file along with the output from... Dans le forum PrusaSlicer	il y a 3 years
	Correction: I was printing 0.15mm layer height - but - layer... Dans le forum PrusaSlicer	il y a 4 years
	so this 7x7mm 45° tower was printed with a 0.3mm E3D NozzleX... Dans le forum PrusaSlicer	il y a 4 years
	Prusa Slicer possibly overextruding with 0.3mm nozzle Dans le forum PrusaSlicer	il y a 4 years
	this is the print config I use [print:Fine Details] avoid... Dans le forum PrusaSlicer	il y a 4 years
	Printing very bad overhangs with PETG and 0.3mm nozzle Dans le forum PrusaSlicer	il y a 4 years
	just saw that this is no permanent solution - well maybe thi... Dans le forum PrusaSlicer	il y a 4 years
	Thank you - that's exactly what I was looking for! Dans le forum PrusaSlicer	il y a 4 years
	Shortcuts for e.g. top and bottom fill pattern Dans le forum PrusaSlicer	il y a 4 years

Statistiques du forum

585 Forums

68.1 K Sujets

477 K Messages

9 En-ligne

75.7 K Membres

Le dernier des messages: Has anyone tried Siraya Tech Fibreheart PPA yet? Notre nouveau membre: Tommy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé