|
Thank you @neophyl - not pasting over the machine limits of ... In forum PrusaSlicer |
3 years ago |
|
@Diem - interesting. What would you propose to change concer... In forum PrusaSlicer |
3 years ago |
|
While I really appreciate all of your hints my main issue st... In forum PrusaSlicer |
3 years ago |
|
RE: Prusa Slicer possibly overextruding with 0.3mm nozzle In forum PrusaSlicer |
3 years ago |
|
This is Prusa Slicer (left - 2:28h print time) vs Slic3r (ri... In forum PrusaSlicer |
3 years ago |
|
The printer was an Ender2 but I switched the hotend to an or... In forum PrusaSlicer |
3 years ago |
|
Thanks! I printed the part on my other printer with the same... In forum PrusaSlicer |
3 years ago |
|
I reduced the small perimeter speed from 15mm/s to 5mm/s as ... In forum PrusaSlicer |
3 years ago |
|
@Swiss_Cheese This 7x7mm tower is just for quick tests - I g... In forum PrusaSlicer |
3 years ago |
|
Hey guys! I included the 3mf file along with the output from... In forum PrusaSlicer |
3 years ago |
|
Correction: I was printing 0.15mm layer height - but - layer... In forum PrusaSlicer |
3 years ago |
|
so this 7x7mm 45° tower was printed with a 0.3mm E3D NozzleX... In forum PrusaSlicer |
3 years ago |
|
Prusa Slicer possibly overextruding with 0.3mm nozzle In forum PrusaSlicer |
3 years ago |
|
this is the print config I use
[print:Fine Details]
avoid... In forum PrusaSlicer |
3 years ago |
|
Printing very bad overhangs with PETG and 0.3mm nozzle In forum PrusaSlicer |
3 years ago |
|
just saw that this is no permanent solution - well maybe thi... In forum PrusaSlicer |
3 years ago |
|
Thank you - that's exactly what I was looking for! In forum PrusaSlicer |
3 years ago |
|
Shortcuts for e.g. top and bottom fill pattern In forum PrusaSlicer |
3 years ago |
