Prusa3D Forum

Notifications

Clear all

Skupina: Registrovaný

Přidal se: 2023/03/02

Active Member

	Great - thank you all for your help. I have created a brim ... In forum How do I print this? (Printing help)	před 2 years
	Model lifting up at the sides In forum How do I print this? (Printing help)	před 2 years
	Prusa Slicer 2.6 doesnt show "template" tab for color printi... In forum Hardware, firmware and software help	před 2 years
	Thank you - this worked In forum Hardware, firmware and software help	před 2 years
	Thank you - attached. -1.50 IMG_2855.jpeg In forum Hardware, firmware and software help	před 2 years
	any other thoughts on this? I tried to clean and have also ... In forum Hardware, firmware and software help	před 2 years
	Thanks - I will try that. In forum Hardware, firmware and software help	před 2 years
	3d print suddenly not sticking - help! In forum Hardware, firmware and software help	před 2 years
	Understand! thank you for the reply - I will print it in pa... In forum How do I print this? (Printing help)	před 3 years
	How do I fix these strings forming.... In forum How do I print this? (Printing help)	před 3 years
	Stringing - how do I prevent this!? thank you In forum How do I print this? (Printing help)	před 3 years
	Thank you In forum PrusaSlicer	před 3 years
	Howmuch of a difference does 0.05mm, 0.07mm etc quality make In forum PrusaSlicer	před 3 years

Fórum Statistiky

585 Fóra

68 K Témata

476.7 K Příspěvky

12 Online

75.7 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed