|
Well I may have cracked it!...rebuilt the hotend with genuin... In forum Hardware, firmware and software help |
4 years ago |
|
I tried a PTFE lined heat break today, with a Capricorn tube... In forum Hardware, firmware and software help |
4 years ago |
|
The filament doesn't fall freely down the original PTFE spar... In forum Hardware, firmware and software help |
4 years ago |
|
@cwbullet I ordered some nozzles, but stupidly ordered 0.5 i... In forum Hardware, firmware and software help |
4 years ago |
|
@cwbullet I am not sure what to do with it, I have put the o... In forum Hardware, firmware and software help |
4 years ago |
|
Still no resolution to my problem, Prusa sent me another new... In forum Hardware, firmware and software help |
4 years ago |
|
After doing more prints today, the above did not fix the pro... In forum Hardware, firmware and software help |
4 years ago |
|
Forgot to mention in the the above test was without moving t... In forum Hardware, firmware and software help |
4 years ago |
|
I am running the latest firmware now and just tested again w... In forum Hardware, firmware and software help |
4 years ago |
|
@doctorshtein Hi, Still no solution, I also did a live chat ... In forum Hardware, firmware and software help |
4 years ago |
|
@tim-2 I did the test cube a couple times the other day, and... In forum Hardware, firmware and software help |
4 years ago |
|
Installed the new temp sensor but it made no difference. Re-... In forum Hardware, firmware and software help |
4 years ago |
|
@doctorshtein Hi, I am having what looks to be the same prob... In forum Assembly and first prints troubleshooting |
4 years ago |
|
@tim-2 Thanks Tim, looks like @doctorshtein problem is the s... In forum Hardware, firmware and software help |
4 years ago |
|
@tim-2 It was the side hot end fan, not the print fan, but i... In forum Hardware, firmware and software help |
4 years ago |
|
Update, just tried a new print today, and it's under extrudi... In forum Hardware, firmware and software help |
4 years ago |
|
@diem Given the sheet a good clean today with hot water and ... In forum Hardware, firmware and software help |
4 years ago |
|
@tim-2 I'm using colorfabb pla and print at 205 on another p... In forum Hardware, firmware and software help |
4 years ago |
|
@tim-2 It's the MK3S @swiss_cheese No not noticed it switchi... In forum Hardware, firmware and software help |
4 years ago |
|
@tim-2 Hopefully this zip works? I've just tried setting the... In forum Hardware, firmware and software help |
4 years ago |
