Notifications
Clear all
Matthias
Skupina: Registrovaný
Přidal se: 2018/04/11
Active Member
1
|
Alright short update about this topic: Re-greased the linear... In forum Hardware, firmware and software help |
před 1 year | |
|
Horrible Frequency on the XL In forum Hardware, firmware and software help |
před 1 year | |
|
@tim-m30 Thank you very much for those inputs. I feel bette... In forum PrusaSlicer |
před 5 years | |
|
Bad Prints when using Support In forum PrusaSlicer |
před 5 years | |
| i calibrated the Z and fine tuned the Z. The Problm only is... | před 6 years | |
| The adhesion of the metal plate is good its stiking properly... | před 6 years | |
| 0.25 Nozzle Problems | před 6 years | |
| Im so confused.. | před 6 years | |
|
T Rex 38 Hours Failed Print In forum How do I print this? (Printing help) |
před 7 years |