Notifications
Clear all
Matthias
Group: Registered
Joined: 2018/04/11
Active Member
1
|
Alright short update about this topic: Re-greased the linear... In forum Hardware, firmware and software help |
10 months ago | |
|
Horrible Frequency on the XL In forum Hardware, firmware and software help |
11 months ago | |
|
@tim-m30 Thank you very much for those inputs. I feel bette... In forum PrusaSlicer |
5 years ago | |
|
Bad Prints when using Support In forum PrusaSlicer |
5 years ago | |
| i calibrated the Z and fine tuned the Z. The Problm only is... | 6 years ago | |
| The adhesion of the metal plate is good its stiking properly... | 6 years ago | |
| 0.25 Nozzle Problems | 6 years ago | |
| Im so confused.. | 6 years ago | |
|
T Rex 38 Hours Failed Print In forum How do I print this? (Printing help) |
6 years ago |