Matt3o – Activité – Prusa3D Forum

Notifications

Clear all

Matt3o

Groupe: Enregistré

A(ont) rejoint: 2016/09/18

Trusted Member

	It's called "Z Seam Alignment". Not sure if it was already i... Dans le forum General discussion, announcements and releases	il y a 8 years
	Comparing slic3r and simplify3d options I noticed something ... Dans le forum General discussion, announcements and releases	il y a 8 years
	I find Cura generates very nice paths with minimal effort, w... Dans le forum General discussion, announcements and releases	il y a 8 years
	if only it was a bit faster (and cheaper) to make tests! Dans le forum Others (Archive)	il y a 8 years
	thanks serge, I definitely need to play around with the slic... Dans le forum Others (Archive)	il y a 8 years
	After a lot of testing I was able to fix most of the issues.... Dans le forum Others (Archive)	il y a 8 years
	thanks for your help PJR I sliced the base and the top of t... Dans le forum Others (Archive)	il y a 8 years
	it's all by default so far. 6 top layers, 4 bottom layers. Dans le forum Others (Archive)	il y a 8 years
	You can use feature in the slicer to detect the printing tim... Dans le forum Others (Archive)	il y a 8 years
	thanks for your reply guys. It's weird because I printed oth... Dans le forum Others (Archive)	il y a 8 years
	What does cause this kind of glitches (globs)? Dans le forum Others (Archive)	il y a 8 years

Page 4 / 4 Précédent

Statistiques du forum

565 Forums

64.2 K Sujets

449.4 K Messages

19 En-ligne

70.3 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé