Activity
 
Notifications
Clear all
Matt
Matt
Group: Registered
Joined: 2017/08/04
Active Member
1
Not sure if anyone else just got hit with a batch change, I ...

In forum General discussion, announcements and releases

4 months ago
Hi Hans, the first thing I can think of is perhaps you over ...

In forum Assembly and first prints troubleshooting

5 years ago
I ended running the PID calibration again and this has fixed...

In forum Hardware, firmware and software help

5 years ago
Well, that didn't work, the moment it started the second lay...

In forum Hardware, firmware and software help

6 years ago
Just in case someone else has the same issue. I was able to...

In forum Hardware, firmware and software help

6 years ago
Self Check produces error - Hot-end heater or thermistor not...

In forum Hardware, firmware and software help

6 years ago
Here is an update on my y-axis skipping or layer shift. I t...

In forum Hardware, firmware and software help

7 years ago
Joan, thank you so much for the response. I spent a few hou...

In forum Hardware, firmware and software help

7 years ago
Y Axis crash detection and skipping on MK3

In forum Hardware, firmware and software help

7 years ago
Thanks Joan!, you were spot on. I didn't see the screw hole...

In forum Prusa i3 kit (Archive)

8 years ago
I just checked the steppers and they all have their retainin...

In forum Prusa i3 kit (Archive)

8 years ago
I have been looking over the assembly instructions and it lo...

In forum Prusa i3 kit (Archive)

8 years ago
Misc Part

In forum Prusa i3 kit (Archive)

8 years ago
Thank you Aaron, based off your response I found the PID Tun...

In forum Others (Archive)

8 years ago
Extruder Temperature Fluctuation

In forum Others (Archive)

8 years ago
Share: