Notifications
Clear all
matrosov
matrosov
Group: Registered
Joined: 2019/08/11
Active Member
1
@bobstro For me it was a kit build but I've had it for awhil...

In forum How do I print this? (Printing help)

5 years ago
I am starting to suspect the controller issue as well. It d...

In forum How do I print this? (Printing help)

5 years ago
I got 3.9R firmware, same issue, it wouldn't even go thru s...

In forum How do I print this? (Printing help)

5 years ago
@mdaneman SD, it's been all over the place for me ever since...

In forum How do I print this? (Printing help)

5 years ago
@mdaneman SD, it's been all over the place for me ever since...

In forum How do I print this? (Printing help)

5 years ago
@mdaneman SD it's been all over the place for me ever since ...

In forum How do I print this? (Printing help)

5 years ago
Thank you. I have 3.8.1 Is 3.9 RC on github ?

In forum How do I print this? (Printing help)

5 years ago
Thanks a lot let me try doing this. It is interesting that ...

In forum How do I print this? (Printing help)

5 years ago
Weird Layer issue shift on this model.

In forum How do I print this? (Printing help)

5 years ago
So in my case it was as I suspected a motor. When I unplugg...

In forum Hardware, firmware and software help

5 years ago
The bearings and rods are greased nicely. It's really the m...

In forum Hardware, firmware and software help

5 years ago
Weird X axis issues.

In forum Hardware, firmware and software help

5 years ago
@tim-m30 Thanks, let me see if I can reset it. I tripple ch...

In forum Hardware, firmware and software help

5 years ago
X axis calibration error after flashing firmware

In forum Hardware, firmware and software help

5 years ago
Were you able to fit enclosure cover that goes over the term...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Share: