Avisos
Vaciar todo
Marcelismus
Grupo: Registrado
Registrado: 2020/10/27
Active Member
1
I had a similar problems before. What helps: Connect a PTFE ... En el foro Hardware, firmware and software help |
hace 6 months | |
I have it currently also with FW 4.7.x and 5.0.0. Support sa... En el foro Input Shaper (MK4) |
hace 10 months | |
Crashes are listed in the menu under "Info -> Print Stati... | hace 11 months | |
The 20% (without IS) comes from the fact that Prusa has stor... | hace 11 months | |
If you want to load filament immediately after turning on th... En el foro Hardware, firmware and software help |
hace 3 years | |
The Bondtech extruder is a bit lower than the original, so t... | hace 3 years | |
I forgot a "no" there. 😉 En el foro Assembly and first prints troubleshooting |
hace 3 years | |
I had a (maybe) same problem with my Mini from October 2020 ... En el foro Assembly and first prints troubleshooting |
hace 3 years | |
Hello everyone, I've had my Prusa Mini (the first 3D printer... En el foro Assembly and first prints troubleshooting |
hace 4 years |