Prusa3D Forum

Notifications

Clear all

marc b

Groupe: Enregistré

A(ont) rejoint: 2022/04/05

Active Member

	Successfully updated to 6.1.3 using another USB KEY formatte... Dans le forum Hardware, firmware and software help	il y a 11 months
	Cannot update firmware after 6.0.1 Dans le forum Hardware, firmware and software help	il y a 11 months
	HelloOrdered and changed the nozzleMy MK4 is back to life 🙂 Dans le forum Hardware, firmware and software help	il y a 1 year
	RE: Hotend fall into bed, bent nozzle 🙁 Dans le forum Hardware, firmware and software help	il y a 1 year
	Hotend fall into bed, bent nozzle 🙁 Dans le forum Hardware, firmware and software help	il y a 1 year
	Hello I managed to adjust the Z level quite well I think I'v... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Hello Sorry I did not get your explainations about Pinda and... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Next I'm trying to print the 75x75 square for more clues Dans le forum How do I print this? (Printing help)	il y a 3 years
	Hello I've tried the "Karl-Herbert" calibration method (slic... Dans le forum How do I print this? (Printing help)	il y a 3 years
	I've cleaned the surface with dish soap (as usual, for me it... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Issues with basic prints Dans le forum How do I print this? (Printing help)	il y a 3 years
	I could not remember which side it was... I have to reprint ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	I've tried lied down ; with another issue (maybe because of ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Thanks a lot for all your answersIndeed I will try to print ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Parameters of prusa slicer : 0.2mm, supports on base onlyUsu... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Issues printing small parts Dans le forum How do I print this? (Printing help)	il y a 3 years

Statistiques du forum

585 Forums

68.2 K Sujets

477.7 K Messages

13 En-ligne

75.9 K Membres

Le dernier des messages: Are there any apps for testing g-code on a Core One Notre nouveau membre: mnentwig Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé