English
Forums
Members
marc b
Activity
 
Notifications
Clear all
marc b
marc b
Group: Registered
Joined: 2022/04/05
Active Member
1
Profile Activity
Successfully updated to 6.1.3 using another USB KEY formatte...

In forum Hardware, firmware and software help

 2 weeks ago
Cannot update firmware after 6.0.1

In forum Hardware, firmware and software help

 2 weeks ago
HelloOrdered and changed the nozzleMy MK4 is back to life 🙂

In forum Hardware, firmware and software help

 6 months ago
RE: Hotend fall into bed, bent nozzle 🙁

In forum Hardware, firmware and software help

 6 months ago
Hotend fall into bed, bent nozzle 🙁

In forum Hardware, firmware and software help

 6 months ago
Hello I managed to adjust the Z level quite well I think I'v...

In forum How do I print this? (Printing help)

 2 years ago
Hello Sorry I did not get your explainations about Pinda and...

In forum How do I print this? (Printing help)

 2 years ago
Next I'm trying to print the 75x75 square for more clues

In forum How do I print this? (Printing help)

 2 years ago
Hello I've tried the "Karl-Herbert" calibration method (slic...

In forum How do I print this? (Printing help)

 2 years ago
I've cleaned the surface with dish soap (as usual, for me it...

In forum How do I print this? (Printing help)

 2 years ago
Issues with basic prints

In forum How do I print this? (Printing help)

 2 years ago
I could not remember which side it was... I have to reprint ...

In forum How do I print this? (Printing help)

 3 years ago
I've tried lied down ; with another issue (maybe because of ...

In forum How do I print this? (Printing help)

 3 years ago
Thanks a lot for all your answersIndeed I will try to print ...

In forum How do I print this? (Printing help)

 3 years ago
Parameters of prusa slicer : 0.2mm, supports on base onlyUsu...

In forum How do I print this? (Printing help)

 3 years ago
Issues printing small parts

In forum How do I print this? (Printing help)

 3 years ago
Share: