Prusa3D Forum

Notifications

Clear all

Mao

Groupe: Enregistré

A(ont) rejoint: 2016/12/12

Active Member

	Bug in Slic3r. Part of text is left out. Here is the object:... Dans le forum General discussion, announcements and releases	il y a 6 years
	I got rid of the bulge by using std setting ie. only 2 perim... Dans le forum How do I print this? (Printing help)	il y a 6 years
	I got rid of the bulge by using std setting ie. only 2 perim... Dans le forum How do I print this? (Printing help)	il y a 6 years
	Strange unwanted bulge on my print Dans le forum How do I print this? (Printing help)	il y a 6 years
	Thanks Peter! I think acceleration can be set also in Slic3r... Dans le forum Others (Archive)	il y a 8 years
	I think that the belts are ok and no belt slipping is happen... Dans le forum Others (Archive)	il y a 8 years
	Pint failure on larger area print Dans le forum Others (Archive)	il y a 8 years
	I had the same issue because of disk named "Macintosh HD". I... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	It printed well without supports about an hour faster. 🙂 Dans le forum Others (Archive)	il y a 8 years
	Printing 3DBenchy Dans le forum Others (Archive)	il y a 8 years

Statistiques du forum

565 Forums

64.5 K Sujets

451.9 K Messages

24 En-ligne

71.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé