Activité
 
Notifications
Clear all
Malabor
Malabor
Groupe: Enregistré
A(ont) rejoint: 2021/04/21
Eminent Member
2
So I need to crack open the case on the printer?

Dans le forum General discussion, announcements and releases

il y a 9 months
Created a Blob...a spark...and then nothing. 🙁

Dans le forum General discussion, announcements and releases

il y a 9 months
Yeah, to be honest, I'm almost a little scared to mess with ...

Dans le forum Hardware, firmware and software help

il y a 3 years
so after taking the mods advice, and chatting with tech supp...

Dans le forum Hardware, firmware and software help

il y a 3 years
Do you know if chat has specific hours of operation or are t...

Dans le forum Hardware, firmware and software help

il y a 3 years
See pics below. After doing some both minor and major adjus...

Dans le forum Hardware, firmware and software help

il y a 3 years
whoops...well, I'm still SUPER new to 3d printing, so please...

Dans le forum Hardware, firmware and software help

il y a 3 years
I'll give a shot tonight and see if I can make some of those...

Dans le forum Hardware, firmware and software help

il y a 3 years
attempting to post the photo of the calibration test square....

Dans le forum Hardware, firmware and software help

il y a 3 years
trying again to post the video, Attachment removed

Dans le forum Hardware, firmware and software help

il y a 3 years
video of "failure"

Dans le forum Hardware, firmware and software help

il y a 3 years
I mean it fails the self leveling test performed before ever...

Dans le forum Hardware, firmware and software help

il y a 3 years
yes, Up until these recent fails, I've been able to print no...

Dans le forum Hardware, firmware and software help

il y a 3 years
I've been having this exact same issue, and the tests are al...

Dans le forum Hardware, firmware and software help

il y a 3 years
I'll give that a shot and see if it makes a difference. But...

Dans le forum Hardware, firmware and software help

il y a 3 years
I'm having the same issues. One day it was working fine, t...

Dans le forum Hardware, firmware and software help

il y a 3 years
Thanks! I'm digging into some of the Prusa vids. There's a ...

Dans le forum General discussion, announcements and releases

il y a 3 years
Help! My mini made a mess!

Dans le forum General discussion, announcements and releases

il y a 3 years
got it up and running after a restart and then a "forced" ac...

Dans le forum Hardware, firmware and software help

il y a 3 years
there's a manual control for the fans in the settings?

Dans le forum Hardware, firmware and software help

il y a 3 years
Page 1 / 2
Partager :