Prusa3D Forum

Notifications

Clear all

majestix508

Skupina: Registrovaný

Přidal se: 2018/05/09

Active Member

	This part solved my issue:/p> In forum Assembly and first prints troubleshooting	před 10 months
	I have the same issue - y calibration failed. In forum Assembly and first prints troubleshooting	před 10 months
	OpenSource/OpenHardware and the MK4 In forum General discussion, announcements and releases	před 2 years
	Today I asked prusa-support the same an their awnser was - t... In forum General discussion, announcements and releases	před 2 years
	1.) 32bit controller and touchscreen would be good (also wif... In forum General discussion, announcements and releases	před 6 years

Fórum Statistiky

595 Fóra

68.8 K Témata

481.5 K Příspěvky

11 Online

77.4 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed