|
I wanted to give an update. I think that I found a solution!... In forum Hardware, firmware and software help |
před 4 years |
|
Well, I managed to glue the extruder body well enough to be ... In forum Hardware, firmware and software help |
před 5 years |
|
So I got my PINDA probe sorted out for now. I also just re-r... In forum Hardware, firmware and software help |
před 5 years |
|
Ok. I am applying epoxy now. It there a extruder body that y... In forum Hardware, firmware and software help |
před 5 years |
|
No. Mostly PLA, with some PETG. I tried ABS a bit, but was m... In forum Hardware, firmware and software help |
před 5 years |
|
I believe that I have solved the extrusion rate/poor print q... In forum Hardware, firmware and software help |
před 5 years |
|
Cracked Extruder Body - Can I Save It? In forum Hardware, firmware and software help |
před 5 years |
|
So my print quality has improved tremendously, but I'm still... In forum Hardware, firmware and software help |
před 5 years |
|
Ok. So after I recentered and lubricated the extruder gear p... In forum Hardware, firmware and software help |
před 5 years |
|
I adjusted the drive gear pin, and the results are promising... In forum Hardware, firmware and software help |
před 5 years |
|
Well to further diagnose the problem, printing with PETG is ... In forum Hardware, firmware and software help |
před 5 years |
|
So the average time to a jam has shortened to about 10 mins.... In forum Hardware, firmware and software help |
před 5 years |
|
So no positive results so far from changing the extruder mul... In forum Hardware, firmware and software help |
před 5 years |
|
So good news, bad news. I tried printing a Benchy at with th... In forum Hardware, firmware and software help |
před 5 years |
|
I printed a small cube with the extruder multiplier set to 1... In forum Hardware, firmware and software help |
před 5 years |
|
Ok, we may be onto something now. I apologize for the sidewa... In forum Hardware, firmware and software help |
před 5 years |
|
I haven't messed with any of those settings. I'll try to rea... In forum Hardware, firmware and software help |
před 5 years |
|
Here is the frog from the above zip file. The same layer iss... In forum Hardware, firmware and software help |
před 5 years |
|
Attached is the 3MF file (assuming I did it correctly). The ... In forum Hardware, firmware and software help |
před 5 years |
|
Hello, sorry for the delay. Attached is an image of the fil... In forum Hardware, firmware and software help |
před 5 years |
